AC Installation in Gated Oak Ridge, FL

AC Installation Done to the Manufacturer's Spec

A new air conditioner only delivers the efficiency on its label if the installation is right. Sizing, refrigerant charge, airflow, and duct condition decide whether a system runs quietly for fifteen years or becomes a service call every summer. Our AC installation work treats all four as part of the job rather than as details to sort out later.

Every installation starts with load: square footage, insulation, window area, duct condition, and layout. Equipment gets matched to that number. An oversized unit short cycles, leaves rooms humid, and wears itself out faster, which is why guessing from the old unit's nameplate is not good enough.

What an AC Installation Includes

• Load calculation and equipment selection matched to the building
• Removal and disposal of the old system
• New condenser, air handler or coil, and line set
• Duct repair, sealing, or modification where the existing ductwork limits the system
• Electrical, disconnect, and thermostat wiring
• Condensate drain and overflow protection
• Verified startup: charge weighed in, airflow measured, controls tested
• A walkthrough of the new system and its settings before we leave